AC Power Connection

A.C. Power Input (& voltage selection)

Before applying A.C. power to the unit, the user must insure that the Bathy-500MF recorder has been properly configured with regard to A.C. voltage (115 or 230). Jumpers on the left side of the P/N P01080 Power Supply PCB must be reconfigured as shown below. For safety reasons the A.C. Power cable must not be placed into the center plate connector while jumpers are removed or installed. The power cable should be unplugged whenever the protective plastic cover is removed from the unit .

NOTE: Bathy-500MF units are shipped from the factory configured for 115 volts A.C.

AC Power Jumper Configuration

Should it become necessary to add additional cable or to repair the P/N P01183 A.C. Power Cable, the user should refer to the plug wiring diagram below.

AC Power Wiring Diagram

115 / 230 VAC (internal jumper selectable) 50 / 60 Hz; 20 Watts Nominal