|
or checkout Survey Photos |
The transducer must be fully immersed in water and not
subjected to air bubbles or turbulent water flowing across the radiating
face.
The transducer can be mounted to an adapter plate or fairing. Then the plate or fairing is bolted or clamped to the pipe. |
|
Attach a line(s) or cable(s) to the pipe near the transducer that will support the pipe from the force of the water when the boat is underway. Clamp the pipe to the gunnel. Fasten the line(s) or cable(s) fore and aft with sufficient tension to support the pipe when the boat is underway. |
Route the cable to the instrument being careful not to tear the cable jacket. To reduce electrical interference, separate the transducer cable from other electrical wiring. Coil any excess cable and secure it in place with zip-ties to prevent damage. Wire the transducer to the StrataBox per diagram: |
Office
(401) 921-5170
Fax (401) 921-5159
